I have looked into this and come up empty. I believe there is a conversion kit for the Sportster but as far as I know nothing for the Bolt or SCR950. If you happen to find something ...
Yep, the maintenance free aspect of the belt is great. What are you hoping to achieve? When you say "shorter belt" it sounds like you are looking for a smaller rear pulley?
The main reason to go with a chain over a belt is suspension travel. Suspension travel is the bane of the belt drive. To get longer shocks with more travel, you need an idler pulley for the belt. This is because the belt will be tightest when the swingarm is parallel to the ground. As you move more away from that perfect parallel position, the belt gets looser and looser and looser, until it's so loose that it will jump teeth or shear teeth. A chain is much more forgiving! It is not supposed to be adjusted as tight as a belt... and if you do adjust it too tight, the chain will stretch pretty quickly. A too-tight belt will just roast your output shaft bearing. Or break, if you're lucky.
Chains are nice because you can easily modify the gearing too. You can technically do that with a belt, but only if someone actually makes pulleys in the size you want.
Why would you need to go chain conversion just to run a 19" rim? Buchanan will get you spokes for your hub, and then just lace on any 19 incher you want. You may have to grind clearance into the swingarm depending on how wide a tire you want to run.
the 19' is bigger(diameter), changing the ratio. Have not spent the time resourcing a smaller rear pulley but i will. I was thinking that if anyone had done a chain conversion it might be easier and less expensive with more available ratios. Just got the bike monday. got a lot to do. Thanks you guys are great !!!!
Wait wait wait. A bigger tire will give you taller gearing. Meaning fewer rpms for the same speed. (potentially a higher top speed if you have the horsepower for it). A smaller rear pulley (fewer teeth) ALSO gives you taller gearing. If you're increasing the overall tire diameter, you'd want to fit a LARGER pulley in order to keep the same RPM for any given speed. Larger pulley = lower gearing = more acceleration and a lower top speed. This would counter a larger wheel/tire combo, which is higher gearing = less acceleration = higher top speed.
A smaller FRONT pulley will have the same effect as a larger REAR pulley, which is lower gearing, more acceleration, higher rpm for any given speed, and a lower overall top speed.
thanks charles,
when i figured out the diameters of the 19 w/tire and 17 w/tire to put all in a gear calculator (pulley sizes, etc). to find out what i would need.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Yamaha SCR950 Forum
17K posts
1.1K members
Since 2016
A forum community dedicated to Yamaha SCR950 motorcycle owners and enthusiasts. Come join the discussion about performance, modifications, classifieds, troubleshooting, maintenance, and more!