Yamaha SCR950 Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
92 Posts
Discussion Starter · #1 ·
Anybody using levers other than what came from the factory? I've got short fingers, and sometimes it's difficult to use the stock levers as they are angled so far away from the bar. Was thinking of heating the stockers and pulling the lever inwards, but not sure of the construction material, and the discoloration that's left behind when finished. I could get them powder coated, but that stuff is super thick, and probably bind in the pivot area
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top