Front and rear Pullys

You may be looking for this: https://www.scr950forum.com/forum/337-engine-technical-discussion/4602-31-tooth-front-pulley.html

Despite my comments on the above link - I’d still give it a go if I found one. Let us know how you get on.
Ben

Burke said:

I looked everywhere I know to find a different pulley when I put a 19” on the rear to no avail. Glad I didn’t because with the 19 it’s much better !!!

Click to expand...

much better in what respect?

19

Bigger wheel/tire lower rpms.
Stock 5th gear at 50mph should be around 2695rpms
With 140/80 19” tire 50mph will be around 2458rpms

jobirobi said:

You may be looking for this: https://www.scr950forum.com/forum/337-engine-technical-discussion/4602-31-tooth-front-pulley.html

Click to expand...

Thanks. Anything for the rear

Burke said:

Bigger wheel/tire lower rpms.
Stock 5th gear at 50mph should be around 2695rpms
With 140/80 19” tire 50mph will be around 2458rpms

Click to expand...

So then you should be able to get more top end out of her correct?

My problem is I ride 100 miles of almost all freeway (a day) at 80 plus, having more speed would be a good thing for me.

How much did it raise the bike? I'm 5'10" short legged :surprise:

So with the lowering kit and 19" rear you are back to the original height?
Did you put the front of the kit on as well or just the rear?

Off topic: other than my SCR I think yours is the best looking machine I have seen. ;^)

Burke said:

Both front and rear.

Click to expand...

:grin2: