Yamaha SCR950 Forum banner

Stubby slip on

396 Views 1 Reply 2 Participants Last post by  Dustyroads
Does anyone have an idea what I need to do to install this cheap slip on I bought to replace the standard exhaust?
I'm guessing I need some kind of short extension with a bend etc.
Planning to install just this for now so will probably need an 02 sensor socket so I can leave it in place for now. Eventually planning on a new airbox & Ivan's reflash but not yet.
Stubby is 50mm ID & adapter goes down to about 42mm OD.
What ID is the standard downpipe ?

Apologies if I've asked this before, I couldn't remember & couldn't find a post.




See less See more
1 - 2 of 2 Posts
There's a bunch of how to's on youtube for making an exhaust for a bolt which is the same.
You'll need 3-6 inches of pipe with a O2 bung welded in it then stick the new muffler on that.
I forget if you need 1 5/8 or 1 3/4 pipe. It only takes a couple minutes to take the stock exhaust off and measure.
  • Like
Reactions: 1
1 - 2 of 2 Posts